SOLP guide slide plate, wear pad, oilless bearing plate - Big Jimmy's Motorcycle Forum
 
LinkBack Thread Tools Display Modes
post #1 of 1 (permalink) Old 05-03-2017, 07:43 AM Thread Starter
New to these parts
 
Join Date: Mar 2017
Posts: 11
SOLP guide slide plate, wear pad, oilless bearing plate

Simple Treatment of Textile Sealed Bearings
New cotton spinning equipment due to dust, heat and high-speed requirements, the use of a large number of SOLP guide slide plate, wear pad, oilless bearing plate. These bearings run a certain period of time, due to internal copper sleeve for lack of oil, resulting in dry and damaged bearings. Such as the import of air spinning machine sealed bearings, the number of good, but the use of a few years later, because they can not be cleaned and replenished grease, so that a large number of sealed bearings damaged scrapped, an increase of equipment failure and unnecessary expenses.

Two simple and effective cleaning and refueling methods are described. The first set of bearing manufacturer cylinder cleaning method, apply to the WF-WB800 Harden Flanged Bearing shell at both ends of the sealed bearings. The method is first soaked in kerosene bearing 1h a 2h, and then according to the bearing diameter size, make special sleeve, both cleaning, but also fuel. Sleeve diameter slightly larger than the bearing diameter 0.05 mm ~ 0.08 mm, slightly lighter than the bearing. Cleaning and refueling steps: the amount of kerosene into the sleeve, the bearing hand pressed into the use of the gap itself bearing, kerosene will be squeezed out, repeated 1 to 2 times; clean and dry and then add the necessary sleeve grease , The bearing into the sleeve with a dry bearing pressure device gently under pressure, the number of bearing refueling according to the needs of flexible control. The second applies to special fully enclosed bearings with a clearance at one end and a setscrew hole. Using the positioning screw hole and the bearing clearance, the first bearing soaked in kerosene in 1 h ~ 2 h, with a special nozzle and oil gun inhaled kerosene, repeated into the bearing 2 or 3 times, dripping with oil gun after the required lubrication Grease can be added.

The above approach applies to a variety of imported or domestic sealed bearings and special sealed bearings, these plastic bearings can be cleaned if the regular fuel, will be able to extend its service life, and can save a lot of money and reduce the occurrence of bad vehicles.
slidebushing is offline  
Sponsored Links
Advertisement
 
Reply

Bookmarks

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Big Jimmy's Motorcycle Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in











Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome